Levelling system Laying system - 4000 lugs for 2.0 mm joint width and 12-20 mm tile thickness
System for levelling tiles during laying
This ingenious system makes it possible to lay tiles absolutely level, fixed and flat.
Overlaps are reliably avoided.
It is quick and easy to use. You save time and get a perfectly laid floor at low cost.
The system can be used both on the floor and on the wall.
It is particularly advantageous for large-format and calibrated tiles.
Surfaces laid with the Hufa levelling system also stand up to critical inspection by your customers.
How it worksThe levelling tabs (white) are inserted into the joints during installation (joint width at least 2.0 mm).
After inserting the neighbouring tile, press the wedge through the tab using the special pliers,
until the surface of both tiles is at the same level
Spacers can also be used.
After the adhesive has hardened, the tabs are simply knocked off or stepped off at the predetermined breaking point.
The tabs must ALWAYS be knocked off/stepped off in the longitudinal direction of the joint ONLY! The wedges can be reused.
The system is no longer recognisable after grouting.
Suitable for all formats and panel thicknesses from 12 to 20 mm.
The joint width must be at least 2.0 mm.
Also for natural stone!
Quantities required per square metre:6 pieces for tile format 120 x 120 cm
8 pieces for tile format 120 x 60 cm
8 pieces for tile format 100 x 100 cm
7 pieces for tile format 90 x 90 cm
9 pcs. for tile format 90 x 60 cm
11 pieces for tile format 60 x 60 cm
25 pieces for tile format 40 x 40 cm
